Alamo 60C Operator's Manual do Operador descarregar pdf (Página 101)

MAINTENANCE

BH20 Series 04/13 Maintenance Section 5-7

MAINTENANCE

MAIN CV DRIVELINE SAFETY SHIELD

To remove the outer CV cone, remove the locking screws from shield cone. Remove cone over yoke. Figure

Mnt-R-0038 Remove bearing ring and remove the locking screws from inner shield cone. Figure Mnt-R-0038.

Turn inner cone to assembly position and remove half shield. Remove bearing ring. FIGURE MNT-R-0038.

To assemble outer CV driveline, grease yoke groove and inner profile tube. Attach bearing ring on groove with

recesses facing profile tube. FIGURE MNT-R-0039. Slide on half shield with cone. Turn cone until it engages

correctly. FIGURE MNT-R-0039. Tighten locking screws. Grease bearing groove in double yoke. FIGURE

MNT-R-0039. Insert bearing ring. Slide guard cone for double yoke over cam from the connecting end. Make

sure holes for screws are visible. FIGURE MNT-R-0039. Tighten locking screws. FIGURE MNT-R-0039.

IMPORTANT!

Check that Guard

Missing decal on

steel tube under

inner guard and

Rotating Driveline

Decal are firmly

affixed, undamaged

and readable. If not,

replace.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 137 138

Sem comentários

Alamo 60C Operator's Manual do Operador Página 101